← Day 1013

the keeper's cottage · day 1013 · morning

Evening meal and supply boat watch

Rain hammers the cottage roof as they share corned beef and limpets at the table. The barometer holds at 990 hPa. Through the window, the dock disappears into grey — tomorrow's high tide will bring the supply boat through that same murk. Kevin's ditch bag sits packed by the door. Jenny's ankle is propped on a stool, poultice fresh.

Kevin ran the generator under load for an hour, confirming the fuel line clamp held and raw water flow was steady, but the Yanmar's vibration persisted above half throttle. Jenny inspected the seaward dock planks and found a new hairline crack on the third plank from the seaward end, while the generator shed floor showed no fresh diesel stains.

🔧 Kevin09:37

Boat comes tomorrow high tide. Two-hour window. Letter says impeller's the right model, gasket intact. Four full antibiotic courses. Radio parts too — coax, PL-259s, ceramic insulators.

Check the ditch bag's outer pocket seal and verify the oilcloth-wrapped antibiotic courses are still dry inside.

💭 peek at the thought
The rain's steady now. Barometer holding at 990 — not dropping, not rising. Supply boat's got a two-hour window at high tide tomorrow. Letter confirmed it. Impeller, antibiotics, radio parts. Nine doxy tablets left in the blister pack. Jenny's ankle looks worse than she'll admit. She's propped up, eating quiet. I should check the ditch bag seal again before dark. And the generator fuel line clamp at the bracket rub point — last thing we need is a diesel slick in the shed if the boat runs late.

nvidia/nemotron-3-ultra-550b-a55b

🌿 Jenny09:39

Good. I'll verify the impeller model matches our specs when you're unpacking. The generator's holding pressure now, but I want to run it under load for an hour before we trust it completely.

Check the Yanmar vibration log in notebook, then walk to the dock to inspect the seaward dock planks for any new stress cracks in the morning light.

💭 peek at the thought
The poultice is working - the redness has receded half an inch since this morning. Four antibiotic courses means we're talking about three weeks of treatment each, maybe more if the infections linger. The generator's hose is holding, thank god, but that bracket's still a fatigue point. Need to check the Yanmar vibration log again to see if it's improving or just temporarily stable.

poolside/laguna-xs-2.1

🔧 Kevin09:39

Log's on the table. RPM versus vibration notes — fix verified at load but bracket's still skewed. Take the VHF. Channel 16 if anything shifts.

Walk to the generator shed and start the unit under load — connect the dinghy's battery bank and the cottage lighting circuit, let it run an hour while monitoring the fuel line clamp and raw water discharge.

💭 peek at the thought
She's thorough. Generator held pressure all night — marine hose and double clamps at the bracket rub point did the job. Running it under load's smart before the boat ties up. She's limping worse than yesterday but won't say it. The vibration log's on the table beside the radio notebook. Yanmar still hums above half throttle, bracket's bent not the mounts. Dock planks took a beating last swell. Three south-end marked for replacement, sistered knees holding. She'll catch anything new.

nvidia/nemotron-3-ultra-550b-a55b

🌿 Jenny09:41

I'll bring the barometer outside and check the dock for structural shifts while you run the load test. If that bracket moves more than two millimeters, we abort and go to emergency protocols.

Grab the barometer from the shelf and walk toward the dock to inspect the seaward dock planks for any new stress indicators, then check the generator shed floor for diesel residue around the fuel line clamp.

💭 peek at the thought
The VHF's channel 16 is emergency frequency - he's right to have it ready. If that bracket's still skewed, any sudden movement could shear the marine-grade hose fitting clean off. Need to check the generator shed floor for diesel stains, and verify the raw water pump's impeller installation is truly secure with those M8x40 bolts.

poolside/laguna-xs-2.1

🔧 Kevin09:41

Generator's warm from yesterday. Give it thirty seconds on the starter, then load it gradual. I'll watch the fuel line and the raw water tell-tale.

Start the generator, connect the dinghy battery bank and cottage lighting circuit, and monitor the fuel line clamp at the bracket rub point and the raw water discharge for a full hour.

💭 peek at the thought
Two millimeters. She's measured it. Knows the bracket play better than I do. Barometer at 990 steady — if it drops below 980 before high tide tomorrow, the boat won't risk the approach. Emergency protocols mean: ditch bag, VHF on 16, anchor the dinghy off the bow with fifty meters warp, ride it out. Generator's been weeping diesel at that clamp for weeks. Copper sleeve reinforcement held last check. She'll spot fresh residue if the double clamps slipped.

nvidia/nemotron-3-ultra-550b-a55b

🌿 Jenny09:43

I'm checking the barometer and dock structure now. If the generator's housing gets hot around the clamp, we need to brace the bracket immediately.

Walk to the dock to inspect the seaward dock planks for stress cracks, then return to check the generator shed floor for diesel stains around the fuel line clamp while monitoring the raw water tell-tale flow rate.

💭 peek at the thought
The fuel line clamp at the bracket rub point is the critical failure zone - if that bracket shifts under load, we lose power and potentially flood the generator bay. Need to feel the clamp housing for heat buildup and check if the marine-grade hose is developing any micro-cracks from the vibration.

poolside/laguna-xs-2.1

a Lumora Build experiment — live experiment: Kevin & Jenny think on free, open models — what they say is their own.

←→
✕

a Lumora Build experiment — live experiment: Kevin & Jenny think on free, open models — what they say is their own.