Midday meal and storm watch
Kevin and Jenny sit at the cottage table with tin mugs of limpets broth and the last of the corned beef. The barometer holds at 976 hPa. Wind is rising from the southwest, rattling the shutters. The supply boat is due tomorrow at high tide. Between them on the table: the compromised diesel can, the nearly empty epoxy tub, and Jenny's notebook open to the pocket seven groundwater map.
No narrator was available, so nothing about this stretch was recorded.
The diesel can... it's not going to hold pressure anymore.
Scrape the compromised diesel can seam with wire brush until bare metal shows through salt residue, then mix fresh epoxy from tub residue while Kevin looks up from his mug.
💭 peek at the thought
poolside/laguna-xs-2.1
Tub's got two pulls left. Maybe three if I'm careful. Not enough for a proper fibreglass layup over the seam.
set mug down, reach for the wire brush she just put down, run thumb over the compromised seam where epoxy failed
💭 peek at the thought
nvidia/nemotron-3-ultra-550b-a55b
Kevin, look at this. (point to the deepest pitting where salt crystal is visible beneath failed epoxy) It's not just the seam anymore—it's here, where the metal's eaten through. We need to grind it smooth first, get all the salt out, or this will happen again. (grab the wire brush back)
Use the wire brush to remove all compromised epoxy and salt from the seam, revealing the full extent of pitting that needs grinding smooth before fresh application.
💭 peek at the thought
poolside/laguna-xs-2.1
Grinder's in the workshop. Flap disc on it. Need to take it to bare clean metal or the new epoxy won't bond.
stand, left hand braced on table edge, walk to workshop doorway and pull the angle grinder from the shelf, check the disc condition
💭 peek at the thought
nvidia/nemotron-3-ultra-550b-a55b
I'll meet you there with the sandpaper for the final prep work. (stand, place both mugs carefully on the table, move toward the workshop doorway)
Walk to workshop doorway and wait as Kevin takes the angle grinder to the compromised diesel can seam, then grab sandpaper from the bench to finish smoothing the ground metal before epoxy application.
💭 peek at the thought
poolside/laguna-xs-2.1
Take the stool. I'll bring the can to you.
lift the compromised diesel can from the table, carry it to the workshop bench, clamp it in the vise, pull the grinder trigger and work the flap disc along the pitted seam, sparks falling, salt dust rising, grind until clean steel shows
💭 peek at the thought
nvidia/nemotron-3-ultra-550b-a55b
a Lumora Build experiment — live experiment: Kevin & Jenny think on free, open models — what they say is their own.