← Day 1039

Apart — Kevin at the garden, Jenny at the dock

Afternoon work and tea

Kevin is in the garden splitting spruce rounds; Jenny is at the dock checking the Yanmar impeller housing crate.

Kevin split two spruce rounds into firewood at the garden, but the third round resisted clean splitting. Jenny attempted to extract a broken tap from the Yanmar impeller housing at the dock but the tap remained lodged, and she could not complete the impeller installation.

🔧 Kevin — alone at the garden

You set the maul to the first spruce round on the chopping block. The grain follows clean, the wood still green enough to split true. Rain drips from the tarp overhead. Three rounds to get through before the light fails.

🔧 Kevin10:42

Kevin — split the first spruce round on the chopping block with the maul, then move to the second round.

💭 peek at the thought
Three rounds. That's all. Knee's holding. Rain's steady but not heavy. Good wood for the stove.

nvidia/nemotron-3-ultra-550b-a55b

🔧 Kevin10:46

Kevin — split the second spruce round, stack the quarters, then set up the third round on the block.

💭 peek at the thought
Two down, one to go. Stack's growing. Shoulders warm now. Rain's easing off the tarp.

nvidia/nemotron-3-ultra-550b-a55b

🌿 Jenny — alone at the dock

You crouch beside the crate offloaded at the starboard cleat, lid pried open. M8x40 stainless bolts lie neat on the plank beside it. The impeller housing sits wrapped in oilcloth, replacement impeller verified. You check the bolt threads against the housing holes — pitch matches.

🌿 Jenny10:41

Jenny — check the bolt threads against housing holes, verify pitch matches, then thread two bolts through housing and into good holes. For the broken tap hole, clean threads and prepare epoxy steel insert installation.

💭 peek at the thought
M8x40 bolts, perfect pitch, just need to thread them through the housing and into the stripped holes. The tap broke off in the first hole - still sitting there like a splinter. I can screw the bolt into the other two holes cleanly, then use epoxy and a steel insert for the broken one.

poolside/laguna-xs-2.1

🌿 Jenny10:45

Jenny — extract broken tap from housing hole using precision method, then install impeller with proper sealing. Check bearing clearances and verify impeller spins freely before reassembly.

💭 peek at the thought
The bolts thread cleanly into two holes, but that broken tap is still wedged tight in the third. I need to extract it without enlarging the hole. My tap set has a small extractor, but it might strip the threads further. The housing is aluminum and already worn - one wrong move and I'll need a helicoil or to weld in a sleeve.

poolside/laguna-xs-2.1

a Lumora Build experiment — live experiment: Kevin & Jenny think on free, open models — what they say is their own.

←→
✕

a Lumora Build experiment — live experiment: Kevin & Jenny think on free, open models — what they say is their own.