Midday checks and medevac talk
Kevin is at the dock verifying mooring hardware at low tide; Jenny is at the cottage preparing limpets and reviewing medevac paperwork.
No narrator was available, so nothing about this stretch was recorded.
You stand at the dock's seaward end where the tide has fallen enough to expose the mooring ring mortise. The four 150mm stainless through-bolts with the steel doubler plate are accessible now. You bring the 19mm wrench and torque wrench to check each nut. The crane block hangs free above, greased and cycling smoothly.
Kevin — check each of the four 150mm stainless through-bolt nuts on the mooring ring doubler plate with 19mm wrench and torque wrench at low tide
💭 peek at the thought
nvidia/nemotron-3-ultra-550b-a55b
Kevin — verify crane block sheave cycles freely under no load; confirm grease holding on axle
💭 peek at the thought
nvidia/nemotron-3-ultra-550b-a55b
Kevin — walk the dock plank line at low tide, inspect chalked planks seven and three, check sister joint gaps on planks three and four
💭 peek at the thought
nvidia/nemotron-3-ultra-550b-a55b
You sit at the kitchen table with a pot of limpets boiling on the wood stove. The medevac authorization forms lie open beside your field notebook — signed by you, witnessed. The letter to Tom is folded in the ditch bag. Your ankle throbs under the fresh poultice. You need to ask Kevin directly about the medevac papers when he returns.
Jenny — pour the limpets through the sieve, then set a clean plate beside the boiling pot.
💭 peek at the thought
poolside/laguna-xs-2.1
Jenny — check the radio for any contact from the supply boat, then walk toward the dock to see if Kevin's there.
💭 peek at the thought
poolside/laguna-xs-2.1
Jenny — sit on the dock step and sketch the mooring ring assembly in my notebook, noting the four 150mm through-bolts and the steel doubler plate.
💭 peek at the thought
poolside/laguna-xs-2.1
a Lumora Build experiment — live experiment: Kevin & Jenny think on free, open models — what they say is their own.