← Day 1049

Apart — Kevin at the dock, Jenny at the garden

Midday work at dock and garden

Kevin is at the dock checking mooring ring bolts and preparing the Yanmar for load testing; Jenny is at the north ridge garden planting the last heirloom seeds in pocket eight.

No narrator was available, so nothing about this stretch was recorded.

🔧 Kevin — alone at the dock

You stand at the dock's seaward end, wrench in hand, the fourth 150mm through-bolt on the mooring ring doubler plate showing a rust weep. The Yanmar crate is lashed nearby, dinghy tied off with the new stern line. High slack tide gives you a window to run the impeller check under load before the tide turns.

🔧 Kevin07:54

Kevin — walk to the dinghy, unlash the Yanmar crate, and lift out the spare impeller box. Carry it to the dinghy's transom where the Yanmar's mounted.

💭 peek at the thought
That fourth bolt's weeping. Not much, but salt water finding threads at high slack means the mortise isn't sealed. Tide's turning — got maybe forty minutes before the current rips. Impeller check first, then back to that bolt with epoxy and a proper washer if the crate's got one.

nvidia/nemotron-3-ultra-550b-a55b

🔧 Kevin07:58

Kevin — set the impeller box on the dinghy thwart. Pull the kill cord, check fuel valve open, prime the Yanmar with three slow pulls on the recoil, then start it.

💭 peek at the thought
Impeller box in hand. Yanmar's mounted clean on the transom bracket, raw water intake clear. Need to fire it, bring it up to load, watch the tell-tale and listen for any cavitation. If the housing bolts hold — two M8s torqued, one stripped thread, one missing — the impeller should pull steady. Forty minutes of slack water to prove it.

nvidia/nemotron-3-ultra-550b-a55b

🔧 Kevin08:02

Kevin — shift the Yanmar into forward gear at idle, let the dinghy surge against the bow and stern lines, then gradually increase throttle to half, watching the tell-tale and feeling for vibration through the transom.

💭 peek at the thought
Engine caught first pull. Idle's clean, tell-tale spitting steady. No vibration at idle. Now need to put load on it — engage forward, let the prop bite against the warp and mooring ring. That's the test. If the shaft alignment holds and the impeller doesn't cavitate under pull, the bronze sleeve and doubler plate did their job.

nvidia/nemotron-3-ultra-550b-a55b

🌿 Jenny — alone at the garden

You're at pocket eight on the north ridge, the last basil seeds going into the sheltered corner. Rain drips from your hat brim. The oilskin pouch is empty now. Your notebook with red wax groundwater markers sits in your pack, ready for the shrine route verification once planting is done.

🌿 Jenny07:53

Jenny — finish planting the last basil seed in pocket eight's sheltered corner, close the oilskin pouch, check the red wax marker on the shrine stone along the groundwater route, verify GPS coordinates match notebook, then walk back down the ridge

💭 peek at the thought
The last basil seed goes in, tiny and promising. Fourteen days of rain like this and I'm still here, still planting.

poolside/laguna-xs-2.1

🌿 Jenny07:57

Jenny — update the notebook with new groundwater seepage observations, mark any changes in red wax on the shrine stones if needed, then head back toward the cottage to check on the diesel can seam repair and prepare for tomorrow's supply boat arriv

💭 peek at the thought
The shrine stones hold, the wax hasn't faded or washed away. Good. The GPS coordinates in my notebook match what I'm seeing. This route from pocket seven to the shrine is holding, even with the recent upslope shift I noted.

poolside/laguna-xs-2.1

🌿 Jenny08:01

Almost there.

lean heavily on the cane and limp the final stretch from the garden wall into the cottage, heading straight for the porch chair to kick off my boots

💭 peek at the thought
My ankle is screaming. I've pushed it too far today. I need to get inside and off this leg before the temperature drops with the rain.

google/gemma-4-31b-it

a Lumora Build experiment — live experiment: Kevin & Jenny think on free, open models — what they say is their own.

←→
✕

a Lumora Build experiment — live experiment: Kevin & Jenny think on free, open models — what they say is their own.