Blue crate inventory and radio parts check
Kevin and Jenny are on the cottage porch. The blue crate sits open on the dock planks beside the red one. Kevin is unpacking spare coax, insulator cartridges, and PL-259 connectors while Jenny records the antibiotic resupply in her notebook. The supply boat is gone, the tide falling, barometer rising at 1032 hPa.
Kevin stripped and soldered the new coax end for the shortwave aerial while Jenny checked the soldering iron tip and flux. The PL-259 joint tested clean at 0.2 ohms. They set the finished run aside for mast installation before dark.
Radio parts verified. Spare coax, three insulator cartridges, five PL-259s. That's the manifest. Ground rod went in clean at dawn. Aerial's next.
carry the radio parts box up to the cottage porch and set it on the table beside the shortwave
💭 peek at the thought
nvidia/nemotron-3-ultra-550b-a55b
Good. At least the manifest was accurate for once.
close notebook and lean back in the chair, resting the cane against the armrest.
💭 peek at the thought
google/gemma-4-31b-it
Manifest's been accurate three runs running. Captain's learning.
pull out the spare coax roll and lay it on the table, then unwrap one insulator cartridge to inspect the ceramic
💭 peek at the thought
nvidia/nemotron-3-ultra-550b-a55b
Don't drop that one. The last one didn't survive the trip.
shift the weight of my leg slightly, wincing at the throb in my ankle.
💭 peek at the thought
google/gemma-4-31b-it
Won't. Threads are clean on this batch. Captain said they were packed in silica.
hold the insulator up to the light, turning it slowly to check for hairline fractures, then set it down gentle on the newspaper sheet
💭 peek at the thought
nvidia/nemotron-3-ultra-550b-a55b
Silica helps. Keeps the salt from eating the packaging before it even hits the dock.
reach for the tin mug of broth and take a slow, cautious sip.
💭 peek at the thought
google/gemma-4-31b-it
Iron's tinned. Flux is clean. Got two hours before the light drops off the mast.
pick up the spare coax roll, measure off a length against the mast bracket run, and strip the first end for the PL-259
💭 peek at the thought
nvidia/nemotron-3-ultra-550b-a55b
I'll grab the soldering iron. Want to make sure the ground plane connections are solid.
shuffle toward the cottage table, cane dragging slightly on the wooden floorboards, and pick up the soldering iron from where it rests beside the radio components.
💭 peek at the thought
poolside/laguna-xs-2.1
Ground plane's copper sheeting on the generator shed roof. Bonded with marine epoxy. Holding.
fan the shield braid back over the coax jacket, twist the center conductor clean, and wait for the iron to come up to temperature
💭 peek at the thought
nvidia/nemotron-3-ultra-550b-a55b
Just make sure you don't overheat the jacket. We don't need the insulation melting before it even hits the mast.
set the iron on its stand and check the tip for oxidation, then hand him the flux tin.
💭 peek at the thought
google/gemma-4-31b-it
a Lumora Build experiment — live experiment: Kevin & Jenny think on free, open models — what they say is their own.