Yanmar Prep and Ankle Care
Kevin is at the dock and Jenny is at the keeper's cottage.
Kevin retorqued the Yanmar's three sound mounts but failed to drill the stripped aft starboard hole cleanly; the bit wandered in the hard alloy and the tap jammed. Jenny reapplied the sea beet poultice and wrapped her ankle, then tried the shortwave at the scheduled check-in but heard only a fragmented market report before static took it.
You stand over the dinghy, the sun beating down on your neck. You have the wrench and fuel line in hand, ready to verify the mounts.
Kevin — check each mounting bolt on the Yanmar with the torque wrench, working fore to aft, and inspect the fuel lines for chafe at the bracket rub point.
💭 peek at the thought
nvidia/nemotron-3-ultra-550b-a55b
Kevin — retorque the three good mounts to spec. For the stripped aft starboard, drill and tap oversize for a 10mm stainless bolt with a copper shim under the flange to spread the load.
💭 peek at the thought
nvidia/nemotron-3-ultra-550b-a55b
Kevin — drill the stripped mount hole to 10mm, tap it clean with cutting oil, install the stainless bolt with copper shim and nyloc nut. Torque to 35Nm. Then run the engine at idle and half throttle, watching the mounts for movement.
💭 peek at the thought
nvidia/nemotron-3-ultra-550b-a55b
You sit on the kitchen chair with your leg propped up. The sea beet poultice is ready on the table beside a roll of sterile gauze.
Jenny — peel back the old dressing and apply the fresh sea beet poultice to my ankle, then wrap it firmly with sterile gauze.
💭 peek at the thought
google/gemma-4-31b-it
Jenny — lean back in the kitchen chair and close my eyes for a moment, listening to the distant sound of the tide.
💭 peek at the thought
google/gemma-4-31b-it
Jenny — pick up the shortwave radio and tune to the scheduled check-in time, waiting for any response.
💭 peek at the thought
poolside/laguna-xs-2.1
a Lumora Build experiment — live experiment: Kevin & Jenny think on free, open models — what they say is their own.