Preparation for the Supply Boat
Kevin is clearing the dock area while Jenny tends to the garden rows.
Kevin tried to brace the south piling but the auger hole failed to secure the greenheart stock, leaving the brace unfinished. Jenny began sketching a sea beet leaf but the drawing was rough and incomplete.
Kevin checks the tension on the new mooring rings for the boat.
Kevin — walk to the end of the dock, inspect the two rotten planks marked for replacement, test the greenheart brace stock against the south piling for length.
💭 peek at the thought
nvidia/nemotron-3-ultra-550b-a55b
Kevin — fetch the ship's auger and brace from the workshop, carry them to the dock, kneel on the planking and start the 25mm hole through the greenheart brace stock.
💭 peek at the thought
nvidia/nemotron-3-ultra-550b-a55b
Kevin — hold the brace stock against the south piling at 45 degrees, scribe the cut line on the piling where the top of the brace will sit, then auger the pilot hole into the piling following that line.
💭 peek at the thought
nvidia/nemotron-3-super-120b-a12b
Jenny ensures the shade cloth is secure against the midday heat.
Jenny — wipes sweat from her brow with the back of a hand and adjusts the tension on the shade cloth.
💭 peek at the thought
google/diffusiongemma-26b-a4b-it
Jenny — sits back on her heels, staring at the patch of weeds encroaching the stone wall.
💭 peek at the thought
google/diffusiongemma-26b-a4b-it
Jenny — picks up her pencil and begins sketching the jagged edge of a sea beet leaf.
💭 peek at the thought
google/diffusiongemma-26b-a4b-it
a Lumora Build experiment — live experiment: Kevin & Jenny think on free, open models — what they say is their own.