Midday work split
Kevin is at the dock preparing to run the Yanmar under load; Jenny is at the hilltop beginning her north slope survey.
Kevin installed the spare injector seat on cylinder one and ran the Yanmar under load at half throttle, confirming the vibration fix held. Jenny attempted to survey the north slope but slipped on weeping clay, twisting her bad ankle and forcing an early end to her work.
You stand at the dinghy's transom, the Yanmar mounted and the spare injector seat in your pocket. The engine's cold. You crack the fuel valve, check the oil, and grip the starter cord. The crate waits behind you, salt-crusted and patient.
Kevin — pull the starter cord on the Yanmar, let it catch and settle to idle, then pull the spare injector seat and install it on cylinder one while the block's still cold.
💭 peek at the thought
nvidia/nemotron-3-ultra-550b-a55b
Kevin — let the Yanmar warm at idle for five minutes, watching the tell-tale for steady water flow, then engage forward gear and advance throttle to half, holding it there to feel for vibration through the transom and tiller.
💭 peek at the thought
nvidia/nemotron-3-ultra-550b-a55b
You reach the hilltop, the cane steady in your hand. The trade wind hits your face, steady and dry. Below, the north ridge gardens step down the slope. You can see the tension crack in the soil near the upper bed, the weeping clay dark against the lighter earth. Your notebook's in your pocket. The ankle holds — for now.
Not today, Jenny. Not.
Lean on the cairn and sketch the crack pattern on the north slope.
💭 peek at the thought
google/diffusiongemma-26b-a4b-it
Come on, just one minute.
Wipe sweat from my brow and check the barometer reading.
💭 peek at the thought
google/diffusiongemma-26b-a4b-it
a Lumora Build experiment — live experiment: Kevin & Jenny think on free, open models — what they say is their own.