Supply boat contact and coax replacement
The supply boat appears on the southern horizon, hull rising on the swell. Kevin has the handheld VHF ready on channel 16. Jenny stands at the mast base with the new coax coil, crutch planted, ready to haul the repaired line up the bracket while the boat is still in range.
Kevin and Jenny completed the shortwave coax splice and established solid ground continuity at 0.2 ohms. Jenny keyed the shortwave and transmitted their status to the supply boat on Tom's frequency. The radio returned only a fragment of a mainland news broadcast about Italian school evacuations, confirming the shortwave receives but the supply boat did not answer.
Channel sixteen. Supply boat Sorrel, this is Sorrel Island caretaker station. Over.
key the VHF handset, hold it level, scan the horizon for the boat's running lights against the grey
💭 peek at the thought
nvidia/nemotron-3-ultra-550b-a55b
Kevin, switch to 72 - I've got radio continuity now but need you to hear me proper. Hand me the coil, I'll run it up while you watch the splice.
Limp forward three steps to the coiled spare coax, unspool the fresh section, hand it to Kevin while leaning on my cane for balance.
💭 peek at the thought
poolside/laguna-xs-2.1
Switching to seventy-two. Coil's yours — mind the PL on the mast end, I resoldered it last night. Continuity held.
flip the VHF to channel 72, hand her the spare coax coil, step back to the radio shelf and key the handset again
💭 peek at the thought
nvidia/nemotron-3-ultra-550b-a55b
Kevin, I need you to stand by the radio shelf with the continuity tester. When I call "splice secure," you verify the ground reading before I key the shortwave.
Clutch the coax coil tighter against my chest, pivot on my good leg, and shuffle the three steps back to the workbench where I can crouch and work on the mast bracket splice without putting full weight on my ankle.
💭 peek at the thought
poolside/laguna-xs-2.1
Copy. Tester's on the shelf. I'll watch the needle. You call it, I read it.
set the VHF handset in its cradle, pick up the multimeter, clip the leads to the radio chassis ground and the coax braid at the feed point, watch the display
💭 peek at the thought
nvidia/nemotron-3-ultra-550b-a55b
Kevin, splice secure - what's the reading?
Crouch on the damp concrete, strip back the coax braid with my teeth, twist the conductors around the mast bracket stud, solder quickly with the torch I'm cradling in my teeth, then heat shrink the joint with the hair dryer I grabbed from t
💭 peek at the thought
poolside/laguna-xs-2.1
Zero point two ohms. Solid ground. Key it.
call out the reading, keep the meter leads steady, glance at the VHF for the boat's return
💭 peek at the thought
nvidia/nemotron-3-ultra-550b-a55b
Kevin, key the shortwave on my mark - three, two, one... NOW.
Grab the shortwave from the shelf, plug in the freshly spliced coax, key the mic and shout into the microphone: "Sorrel Island to supply boat, this is Sorrel Island caretaker station, ground system repaired, diesel can sealed, need immediat
💭 peek at the thought
poolside/laguna-xs-2.1
a Lumora Build experiment — live experiment: Kevin & Jenny think on free, open models — what they say is their own.