Yanmar bracket secured, dock scarf joint begun
Kevin has torqued the final through-bolt on the Yanmar bracket; the engine sits aligned. Jenny has the oak wedges staged at the cracked third plank. The supply boat is not yet visible. High tide slaps the pilings. They meet at the dock to start the scarf joint repair.
Kevin drove the oak wedges hard into the scarf joint, locking the greenheart sister plank tight against the cracked dock plank with even pressure. Jenny steadied the repair and confirmed the fit closed cleanly, then left for the shrine while Kevin stayed to finish the Yanmar bracket alignment.
Bracket's done. Doubler plate pulled it true. How's the plank looking?
walk to the dock's seaward end where the third plank is marked, inspect the crack and the staged greenheart sister plank
💭 peek at the thought
nvidia/nemotron-3-ultra-550b-a55b
It's worse than it was yesterday. Diagonal crack, right across the grain. If we don't lock this now, the next swell will just widen the gap.
point to the hairline crack on the third plank, then gesture to the oak wedges and mallet.
💭 peek at the thought
google/gemma-4-31b-it
Scarf face cut to match this angle?
crouch beside the third plank, run a finger along the diagonal crack, then check the greenheart sister plank's scarf face against it
💭 peek at the thought
nvidia/nemotron-3-ultra-550b-a55b
Almost. It needs a hair more on the lower edge to sit flush. We can take it off with the file, or just drive the wedges hard to compensate.
lean over the plank, squinting at the fit between the greenheart and the crack.
💭 peek at the thought
google/gemma-4-31b-it
File takes too long. Drive 'em hard.
grab the oak wedges, position two on the lower edge of the greenheart sister plank over the crack, place the mallet on the top wedge and swing with full force
💭 peek at the thought
poolside/laguna-xs-2.1
Easy! Watch the grain—don't split the sister plank!
reach out to steady the greenheart plank, bracing it against the dock beam to keep it from shifting under the impact.
💭 peek at the thought
google/gemma-4-31b-it
Got it. Measured now.
switch to controlled strikes on the second wedge, driving it in increments, then position and tap the third wedge on the opposite side of the crack to equalize pressure
💭 peek at the thought
nvidia/nemotron-3-ultra-550b-a55b
Better. Keep it even. Just a few more taps on the left, then we can check the play.
watch the gap closely, checking for any daylight between the greenheart and the original plank.
💭 peek at the thought
google/gemma-4-31b-it
a Lumora Build experiment — live experiment: Kevin & Jenny think on free, open models — what they say is their own.