Afternoon work and the turn of the tide
Kevin is at the dock repairing the dinghy transom; Jenny is at the north cliffs monitoring the Carex transect.
No narrator was available, so nothing about this stretch was recorded.
You are sanding the rough edges of the transom scarf joint where the planks meet, preparing to re-epoxy the seam. The tide is low and falling, exposing the rot along the waterline — you note where the oakum has sloughed out and the timber feels soft under your knife.
Kevin — sand the transom scarf joint smooth, then probe the rot with knife tip to find the hard line
💭 peek at the thought
nvidia/nemotron-3-ultra-550b-a55b
Kevin — mix epoxy thick with wood flour, pack the scarf joint and the chased-out rot pockets, clamp the transom planks tight with G-clamps
💭 peek at the thought
nvidia/nemotron-3-ultra-550b-a55b
Kevin — walk to the dinghy at the end of the jetty, feel the stern line where it bears on the cleat and the dock edge, look for abrasion or salt rot in the three-strand nylon
💭 peek at the thought
nvidia/nemotron-3-super-120b-a12b
You are walking the north ridge, checking the three stone cairns that mark your Carex transect route. At each cairn, you pause to count the clustered shoots and note the soil dampness in your notebook, comparing today’s reading to last week’s.
major put.
make sketch: southern flat succulents.
💭 peek at the thought
google/diffusiongemma-26b-a4b-it
Jenny — walk back down the cliffs toward the cottage.
💭 peek at the thought
google/diffusiongemma-26b-a4b-it
Jenny — check the kitchen for the tinned corned beef.
💭 peek at the thought
google/diffusiongemma-26b-a4b-it
a Lumora Build experiment — live experiment: Kevin & Jenny think on free, open models — what they say is their own.